Used to support grids in place. Can be cut to the desired length or extended by use of the beam joiner. Note that the recess in the top of the beam is designed to take the longest edges of each grid or the tabs on the underside of the outermost grids.
2
Subtotal £40.00
V.A.T @ 17.5% £7.00
Total £47.00
SP11-2300mm-PK2
SP11 2.300m Long Beams Powder Coated Pack 2.
Used to support grids in place. Can be cut to the desired length or extended by use of the beam joiner. Note that the recess in the top of the beam is designed to take the longest edges of each grid or the tabs on the underside of the outermost grids.
2
Subtotal £51.00
V.A.T @ 17.5% £8.93
Total £59.93
SP11-2684mm-PK2
SP11 2.684m Long Beams Powder Coated Pack 2.
Used to support grids in place. Can be cut to the desired length or extended by use of the beam joiner. Note that the recess in the top of the beam is designed to take the longest edges of each grid or the tabs on the underside of the outermost grids.
2
Subtotal £58.68
V.A.T @ 17.5% £10.27
Total £68.95
SP12-1m-PK10
SP12 1m Leg Pack of 10.
The picture shows the leg being cut to length by tree loppers. Legs are supplied in 1 metre lengths, which is the deepest pond that can be protected without a special order being placed. A leg should be placed approximately every 1 metre along each beam and preferably at each end of the beam and at each join.
10
Subtotal £21.50
V.A.T @ 17.5% £3.76
Total £25.26
SP13-PK10
SP13 Support Cord/Rope Pack of 10 m.
The cord passes all the way through each beam and is anchored outside the perimeter of the pond using either ground stakes (SP15) or ceiling anchors (SP16). Excess cord is then cut away. Alternatively, a hole can be drilled 7cm from the end of the beam, on the underside, and a shorter length of rope used and a simple knot tied.
10
Subtotal £17.00
V.A.T @ 17.5% £2.98
Total £19.98
SP14-PK5
SP14 Support Cord/Rope Cover Pack of 5 m.
It may be necessary to protect the support cord from lawnmowers, grass strimmers or animals. This is achieved by using the support cord cover which is passed over the exposed length of cord and cut to length. It is not always required but is included in the standard pack.
5
Subtotal £16.00
V.A.T @ 17.5% £2.80
Total £18.80
SP15-PK10
SP15 Ground Stake (Galv Steel) Pack of 10.
Ground stakes are one of two ways to secure the support cord. These are made from galvanized steel and are 25cm long. The concave face of the stake faces the pond. The support cord passes through the central hole, then into the side hole, over the ‘U’ shaped cut in the top of the stake and down into the loop created. It is then tightened as necessary.
10
Subtotal £20.00
V.A.T @ 17.5% £3.50
Total £23.50
SP16-PK10
SP16 Shielded Anchor Pack of 10.
The shield anchor is used in pond edges such as brick, solid slab edges or solid stone surrounds. A 6.0mm hole is drilled at the relevant point to receive the shield anchor. Tap in the anchor gently to prevent the hole in the anchor from closing up. The support cord is then passed into the hole and a simple knot secures.
